Saturday, April 3, 2010

Batch #1

We are ready to build and ship batch #1. We are going to start with a limited run of 5 units to test the waters. NOTE: We now support shipping internationally, if you have a problem ordering from our website please contact us and we will get it fixed ASAP.
Posted by Brett Fleming at 4:07 PM

4 comments:

  1. AnonymousApril 4, 2010 at 8:58 AM

    Hey I'm interested in buying a kit. Do you include an updated list of the necessary hardware and updated rod lengths?

    ReplyDelete
  2. Brett FlemingApril 4, 2010 at 1:54 PM

    Absolutely! We are almost done with the cad assemblies to generate the final bill of materials. We will have it on the website (either flemingcnc.com or the RepRap) before we ship. The only Rod length that have changed are for the X-Axis (which got shorter) and for the cross pieces that support the z-motor and tensioner (which was reduced from 4 to 2 rods, and are also a bit shorter).

    All of this data will be available this week.

    ReplyDelete
  3. LongertoesApril 4, 2010 at 7:01 PM

    watch out makerbot might attack if you don't post your source files before you sell any

    ReplyDelete
  4. Brett FlemingApril 5, 2010 at 11:39 AM

    I don't think we will gather any attention from MakerBot in regards to Issac. There is nothing in our kit that derives or uses anything from the CupCake. Everything is RepRap/Mendel derived and we plan on keeping it that way :)

    ReplyDelete

Subscribe to: Post Comments (Atom)